You may have noticed boat switch panel doors on your new house.
The panels are the main doors and are the same as those you see on the inside of most boats.
But, they are not as easily seen as the inside doors, so how to install the panel doors?
You will need to remove and install the panels separately from the inside door.
If you want to make a boat switch that can be connected to the outside, you will need a boat-switch panel.
The panel is installed in the same way as the door.
You need to take off the door from inside and lift the panel.
You will find it on the back of the panel, which is not the front of the door but a little lower down.
You can use a pair of pliers to lift the panels from the bottom.
Once you have removed the panel from the panel door, you need to get the panel to the top of the boat.
Pull it out by the door knob and push it up, as shown in the photo below.
The panel should be about three inches above the top edge of the deck.
Now you need a screwdriver to pull the panel out of the wall.
You want to push it through the panel and up the panel so the panel can slide up on the deck as shown here.
Once the panel has been pushed out, it is now ready to be removed.
The screwdriver needs to be very carefully moved back into the panel after the panel is removed.
You’ll need to be careful because the panel may be very heavy.
It’s best to be patient and wait until the panel comes free from the door before removing it.
The screws will come loose once you pull the screw out.
The door knob should then be moved back out.